Carter AccuRight Table Inserts for Band Saws - Pack of 3

Email this page to a friend

Carter AccuRight Table Inserts for Band Saws - Pack of 3

Price : $11.99

Quantity:

Select Product Options Here

Type:

ID1000 - Delta 14 inch and clones
IJ1000 - Jet 14 inch and clones

Detailed Description

Carter AccuRight Table Inserts for Band Saws - Pack of 3

You can make bandsaw cuts that are virtually tearout-free on the exit side of your work thanks to these nylon zero-clearance throat plates. Simply saw a narrow kerf partway through the plate, slide it around the blade into your saw's throat opening, and go to work. Your blades' flexibility means that zero-clearance plates will eventually get chewed up, so the plates are sold in packs of three for ready replacement when needed.

Pack of 3

Specifications

The fit recommendations below are general guidelines.
PLEASE MEASURE YOUR INSERT TO BE SURE YOU ARE ORDERING THE CORRECT ONE.

ID1000 Specifications

Diameter: 2-1/2"
Center thickness: 5/32"
Thickness at edge: 7/64"
Rabbet width: 5/32"
1/8" x 1/16" rounded tab on left-hand side at 9 o'clock
This inserts fits most Delta 14" Cast Iron Bandsaws and clones including the Steel City 14".

IJ1000 Specifications

Diameter: 2-1/2"
Center thickness: 5/32"
Thickness at edge: 7/64"
Rabbet width: 3/8"
1/8" x 1/16" rounded notch on left-hand side at 9 o'clock
This insert fits some Jet 14" Cast Iron Bandsaws and clones. It also fits some Jet 12", & 18" band saws.

Product Warnings

WARNING FOR RESIDENTS OF CALIFORNIA!

This product may expose you to chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Please read our Proposition 65 warning.
For more information, see www.P65Warnings.ca.gov.